NVIP-8DN7560V/IRH-
2P User’s manual ver.1.0 (short form)
All rights reserved © AAT Holding S.A.
9
2.2. NVIP-8DN7560V/IRH-2P mounting
To mount a camera please follow the instructions below:
Unscrew and remove the dome from the camera
Put the camera’s base to wall/ceiling.
Taking holes at the bottom of the camera’s base as
a pattern, please mark the drilling holes
for screws and cables (using a punch, for example).
Drill 2 holes, in accordance with camera’s base hole placement.
Drill cable hole.
Mount the camera base using included screws.
Make connections of the foreseen power and signal cables (detailed description and way of
connecting the electrical connections of the camera is described in detail in chapter 2.1 and 5
of this manual).
Additional to adjust camera module please follow the instructions below:
Loosen the vertical adjustment screw (
“A”
screw).
Point the camera to a desired scene in accordance with figures below
Block vertical adjustment screw (
“A”
screw).
Put dome onto the camera’s base and secure it using screws.
NOTE:
Please note that the wall or ceiling must have enough strength to support the IP Camera.
NOTE:
In order to obtain declared degree of protection please seal the camera base to prevent water
getting inside. Furthermore, when installing the camera on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
START-UP AND INITIAL CAMERA CONFIGURATION
