NVIP
-
2H
-
8002M/LPR, User
’
s manual (short) ver.1.0
All rights reserved © AAT Holding S.A.
13
3.2 Connecting Ethernet cable
To maintain tightness of Ethernet cable connection, please follow instruction below:
1. Loosen the nut (a) from the main element (b).
2. Run power cable (without RJ
-
45 connector) though both elements. Then crimp the cable with RJ
-
45
connector. Install rubber gasket (d) on the connector (c).
3. Connect the cable to the hermetic connector (c), screw main cover (b), then screw the nut (a).
CAUTION!
The other camera connectors are not hermetic. User should seal them by himself.
3.3 Camera installation
Put mounting drawing paper to the wall or ceiling and mark drill holes.
Drill holes using markings.
Drill additional hole for video and power cables.
Using mounting screws from the package, attach the mounting plate of camera to the ceiling/
wall. Align the mounting plate
the
mark facing
.
Make sure the hinge screw is attached to the back of the
INSTALLATION
a
b
a
b
c
d
TOP
Mounting screw
holes
Mounting
plate
Hinge screw
