NVIP-2DN7120SD-2P User’s manual (short form) ver.1.0
All rights reserved © AAT Holding sp. z o.o.
9
2.2. Mounting the camera
CAUTION! Due to safety reasons, maximum load capacity of surface shouldn’t be less than 25kg.
In order to successfully mount a camera, please follow the procedure below:
1. Install the Fixing Plate on the bottom of Camera.
2. Mark the positions of the three screw holes on the Hard Ceiling Mount at the chosen installation
location.
3. In the marked locations, drill each hole slightly smaller than the supplied Screw Anchors and put
supplied Anchors into these drilled holes.
4. Fasten the Hard Ceiling Mount with the three Self-tapping Screws.
5. Thread the Data Cable and/or Ethernet cable through the center hole of the Mount and connect the
cable to the camera body.
CAUTION!
Connection the power cable to the camera must be performed after disconnecting the power
source. Power can be on only after the camera is fully mounted and the protective elements of
camera module are dismounted.
START-UP AND INITIAL CAMERA CONFIGURATION
