3
HSBL CABLE CUTTERS, Order No. 1081
Operative range
Copper and aluminium cables of up to a diameter of 120 mm (4
3
/
4
") can be cut with these cutters.
Technical specifications:
Width:
140
mm
(5.5")
Length with working cylinder
650
mm
(25.6")
Height
350
mm
(13,8")
Weight
3 kg
(6.6 lb)
ATTENTION !
BEFORE ATTACHING AND REMOVING THE SYSTEM TOOLS OR
CARRYING OUT MAINTENANCE WORK, UNCOUPLE THE HYDRAULIC
UNIT OR DISCONNECT IT FROM THE MAINS!
Attaching the Tools:
Place the HSBL cylinder (1) on the stand
(5). Slide the pressure plate (Order No.
1098) (11) on to the piston rod (3) and
tighten the fastening screw.
Slide the cutting edge (Order No. 1097)
(13) between the cylinder spars (4) and
fasten using the bolts (2).
Operation
The mouth can be opened by pulling out a
fixing bolt (2) and by tilting out the edge
(13). This makes it easier to put in longer
cable pieces.
The HA hydraulic unit is switched on and
off by using the foot switch on the unit.
Accessories
A specially ground edge is available for cutting reinforced cables (Order No. 4121)
Maintenance
ATTENTION !
UNCOUPLE THE HYDRAULIC UNIT OR DISCONNECT IT FROM THE MAINS BEFORE CARRYING
OUT MAINTENANCE WORK.
In case of wear or damage:
Replace or regrind cutting edge.
Regrinding
The cutting edge can be reground up to a max. of 4 mm. When the edge is reground,
care should be taken that the edge remains parallel to the edge’s back.
The cutting edge and the pressure piece of the cable cutters are subject to wear and
tear. When changing the cutting edge, the pressure piece should also be changed.