8
Cutting:
1.
Place the rail into the cutting tool and align.
2.
Press the foot switch on the hydraulic unit and keep pressed until cutting is completed.
Return Stroke Limitation:
The return stroke can be adjusted continuously.
Before setting the return stroke, the cutting edge must
have been lowered.
1.1
Lower the cutting edge and keep the foot
switch depressed.
1.2
Turn in the handwheel (14) of the return stroke
screw (15) against the stop in the direction of
the arrow.
1.3
Release the foot switch.
1.4
Turn out the handwheel (14) until the cutting
edge is in the desired position.
Attention!
The cutting edge must not be forced down
with the return stroke screw (15).
ATTENTION !
BEFORE ATTACHING AND REMOVING THE SYSTEM TOOLS OR CARRYING
OUT MAINTENANCE WORK, UNCOUPLE THE HYDRAULIC UNIT OR DIS-
CONNECT IT FROM THE MAINS!
Accessories:
1). Vice (16), Order No. 7030
Description on page 5
2). Length stop (17), Order No. 6990
The length stop (17) is fastened to the
cutting tool by two screws.
Any sizes between 20 and 1600 mm
can be set with the slide (18).