21
Mounting
1. Attach the holder (20), Order No. 4109, with
two cap screws (M10 x 16) (21) to the press
plate (10) in such a way that the top edges of
the holder (20) and press plate (10) are level.
2. While pressing down the catch button (22),
slide the template (23) into the holder (20)
until it reaches the bottom tooling (17) and let
it snap into place.
3. Let go of the catch button (22).
Dismantling
1. Press down the catch button (22).
2. Slide out the template (23).
The width of the rails and hole arrangement are
stated on every template. The rail (24) is to be
centered in the template as shown in pictures 1 to 4.
To get a certain hole arrangement the rail must
always be centered with the same "Y" side on the
template.
Maintenance
ATTENTION !
UNCOUPLE THE HYDRAULIC UNIT OR DISCONNECT IT FROM THE MAINS BEFORE
CARRYING OUT MAINTENANCE WORK.
Punch
Before each tool installation:
Clean the hole for the lower tool. The receptacle must be free from
dirt, shreds etc.
If dirty:
– Clean the seat for the rails.
– Clean the templates.
Every week:
– Clean and grease the HSBL punch.
Tools
See application rules.