NovoPress ACO203, Operating Manual

Page: 24 / 40

ACO203 / ACO203 BT / ECO203
20
EN
Information!
The press device is not suitable for continuous operation. Following 30 minutes
of continuous operation, a short break of at least 15 minutes must be taken to
allow the device to cool down.
• Insert the press jaw/adaptor jaw into the press device as shown in Fig. 5 to 7.
8.2 Meaning of the LED display
LED display Status/cause Measure
All LEDs off. The device is switched off. Briefly press the start button (1) (see
section 7.6).
Green LED (2) lights up. On standby.
Green LED (2) off
(pressing operation in
progress).
Automatic press cycle is on,
device ends the pressing
operation automatically.
Green LED (2) flashes. Insufficient battery charge. Charge or replace battery.
Green LED (2) flashes. Retaining pin not correctly
shut.
Insert retaining pin, or check retaining pin
and cylinder.
Green LED flashes.
(Press device
automatically returns to
initial position.)
Retaining pin has come
loose!
Insert retaining pin, or check retaining pin
and cylinder.
NOTE
The pressing operation may not have
been completed; please check and repeat
if necessary.
Blue LED (10) flashes. The press device is ready
for connection.
The press device can be connected with
the NovoCheck app.
Blue LED (10) lights up. The press device is
connected with the
NovoCheck app.
Red LED (3) flashes. Device not within the
temperature range
The device only works within a
temperature range of -10 to +50°C. If the
red LED is flashing, the device must be
moved into a warmer or colder area. The
device can be warmed to operating
temperature by means of dry runs.
If the device is too warm it must be cooled
down by means of a short break.
Red LED (3) lights up. Device fault. Press the start button (1). If this is
unsuccessful, the press device is
defective.
Send the device to a specialist workshop.
NOTE!
The pressing operation may not have
been completed; please check and repeat
if required.