Novoferm tormatic NovoCon T75 DES, Mounting And Operating Instructions, Page: 17 / 77

Programming overview
1x
3-9
30-
37
Exit
Enter Menu Item
Menu
item
No. Selection
Input
pulse OPEN/pulse CLOSE
pulse OPEN/dead-man CLOSE
dead-man OPEN/dead-man CLOSE
Selection of the operating mode
0... 100mm higher
0... 50mm deeper
Correction of the pre-limit switch for the edge safety
4-wire light barrier Ls5, reflection light barrier
2-wire light barrier LS2
without light barrier
Selection of the light barrier
measurement display (keep button pressed for 5 sec)
Selection of edge safety device
0... 80mm higher
0... 80mm deeper
Fine adjustment of upper end position
Setting the gate in lower position
reverse direction (keep button pressed for 5 sec)
Setting the gate in upper position
Selection
2*
1
0
25 - 99
0 - 25
25*
2
1
0*
No.
3
50 - 99
0 - 50
50*
Input
40
37
36
33
31
30
Menu
item
0... 80mm higher
0... 80mm deeper
Fine adjustment of lower end position
50 - 99
0 - 50
50*
34
- -
35
input switch-off force
off
Opening force limitation
1-30
0* 48
4
2
Power-on time for the motor
1
0*
49
5
3
Light barrier LS5, reflection light barrier, installed in the frame 4
4
* factory setting
Finish menu
- -
Finish menu
25min / 60% drive motor 14.15
25min / 20% drive motor 9.24 WS
drive motor 5.24 25 min/35%
no limitation
drive motor 5.24 WS 25 min/30 %
25min / 60% drive motors 9.24
shockwave strip with testing
electrical safety edge 8K2
optical edge safety device OSE
2
1*
0
4-wire light barrier installed in the frame with testing 6
light barrier LS2 installed in the frame 3
4-wire light barrier with testing 5
wipe pulse with hand-held transmitter
5 min light
warning during the drive
gate open message
gate closed message
Status relay X3
4
3
2
1*
0
45
wipe pulse 5
- -
Finish menu
Finish menu
Deleting all function codes (keep button pressed for 5 sec)
Teaching-in light button for the hand-held transmitter
Teaching-in start button for the hand-held transmitter
60
62
63
- -
Finish menu
three-button control
Functions of external command transmitter J1
1
51
off 0*
- -
Resetting the factory setting
(keep button pressed for 5 sec)
series number production dare -
Software output - -
hours error code
Error memory output - - -
Operating hour counter output
hours
- -
Cycle counter output
- cycles -
30000 cycles
25000 cycles
20000 cycles
16000 cycles
12000 cycles
8000 cycles
4000 cycles
1 000 cycles
no service interval
Pre-selection maintenance cycle for the gate
8
7
6
5
4
3
2
1
0*
90
Finish menu
91
96
97
98
99
- -
9
5
6
pulse generator (OPEN-STOP-CLOSE function) 2
Service
Service interface
1
53 off
0*