NOVO 165- 150, Owner'S Manual

Page: 19 / 40

18 19
Familiarize with Button Configuration:
3.
Power and Program the Valve
Attach the Transformer cable to the valve and plug in the transformer to the 110V Power outlet. you will notice the two screens on right will alternate.
6(77,1*6 83
'2:1 6(/(&7
TIME
08:27 AM
6(77,1*6 83
'2:1 6(/(&7
REMAIN
GAL 1060
1. Press MENU key
to advance to
TIME OF DAY . TIME OF DAY will flash.
6(77,1*6 83
'2:1 6(/(&7
TIME
08:27 AM
2. Press the UP or DOWN key
to adjust the
TIME OF DAY . Press & hold the UP or DOWN key to quickly advance the hour and minutes. When desired time
is displayed press SET
to advance to the
HARDNESS setting. HARDNESS will flash.
6(77,1*6 83
'2:1 6(/(&7
HARDNESS
020GPG
3. Press the UP or DOWN key to adjust the HARDNESS (Min 1.Max 199). When desired hardness is displayed press SET
to advance to the
PEOPLE setting (Min1/
Max9). People will flash.
6(77,1*6 83
'2:1 6(/(&7
PEOPLE
04
4. When desired number of people is displayed press SELECT to complete pro-gramming.
TIME
08:27 AM
KEYPAD
4
Add Salt to the brine tank/cabinet
4. Put 40 kgs of crystal water softener salt in the
brine tank. The unit will automatically fill the
water to the correct level when it regenerates.
BACKWASH
10 MIN
RINSE
10 MIN
BRINE
60 MIN
REFILL
11.1 MIN
1
1.
Connect the transformer
to the valve. Plug the
12-volt transformer into
a 120 VAC 60 Hz outlet.
2.
Open the brine tank /
cabinet salt lid and
add water until there is
approximately 3” (75 mm)
of water in the tank. Do not
add salt to the brine tank at
this time.
STARTUP INSTRUCTIONS
This function is to accept the values if changed and advance to the next page in
the menu.
These buttons are used to increase or decrease the value of the settings while in
the programming mode.
This function is to enter the basic set up information required at the time of
installation.
Key Pad Configuration:
Manual Regeneration Using Keypad
Press “Setting Key” Once for Delayed Regenerations or Hold for 5 Seconds for Immediate Regeneration
Below is the sequence of Regeneration cycles
1.
Backwash
2. Brine Draw and Slow Rinse
3.
Rinse
4. Brine Refill