User Manual
XLP 514/516
2.
As shown, move the end of the label strip around the baffle plate towards the rewinder and fasten
it to the clasp (A).
Observe, that the inner material edge must contact the inner wall on its way to the rewinder.
A
3.
Push the material guiding (A) up to the outer edge of the material without clamping the material:
A
B
4.
Fit the guide disc on the unwinder and push it up to the stop on the roll of material.
5.
Close the print head pressure lever.
What to do next
If the label material is different from the one previously used: Adjust the label sensor.
Edition 1 - 8/2021
70
Operation
Inserting and removing label material