70
Novell eDirectory 8.8 Installation Guide
no
vd
ocx
(e
n)
6 Ap
ril 20
07
The package containing NICI 2.7 is named
NOVLniu0-2.7
on Solaris.
For more information, refer to
Section 4.6.3, “Installing NICI,” on page 74
.
SLP should be installed and configured.
With eDirectory 8.8, SLP does not get installed as part of the eDirectory installation.
If you are a root user, you need to install and configure SLP before proceeding with the
eDirectory installation.
If you are a nonroot user, SLP should be installed and configured before you proceed with the
eDirectory installation. A nonroot user cannot install SLP.
For more information on installing SLP, refer to
“Using SLP with eDirectory” on page 73
.
Enable the Solaris host for multicast routing.
To check if the host is enabled for multicast routing, enter the following command:
/bin/netstat -nr
The following entry should be present in the routing table:
224.0.0.0
host_IP_address
If the entry is not present, log in as root, and enter the following command to enable multicast
routing:
route add -net 224.0.0.0 -net 224.0.0.0 netmask 240.0.0.0 hme0
If you have more than one server in the tree, the time on all the network servers should be
synchronized.
Use Network Time Protocol's (NTP) xntpd to synchronize time. If you want to synchronize
time on Linux, Solaris, AIX, or HP-UX systems with NetWare
®
servers, use
timesync.nlm
5.09 or later.
(Conditional) If you are installing a secondary server, all the replicas in the partition that you
install the product on should be in the On state.
(Conditional) If you are installing a secondary server into an existing tree as a nonadministrator
user, ensure that you have the following rights:
Supervisor rights to the container the server is being installed into.
Supervisor rights to the partition where you want to add the server.
NOTE:
This is required for adding the replica when the replica count is less than 3.
All Attributes rights: read, compare, and write rights over the W0.KAP.Security object.
Entry rights: browse rights over Security container object.
All Attributes rights: read and compare rights over Security container object.
(Conditional) If you are installing a secondary server into an existing tree as a nonadministrator
user, ensure that at least one of the servers in the tree has the same or higher eDirectory version
as that of the secondary being added as container admin. In case the secondary being added is
of later version, then the schema needs to be extended by the admin of the tree before adding
the secondary using container admin.
Configuring Static IP Address
Refer to
“Configuring Static IP Address” on page 12
for more information on configuring static IP
addresses.
Summary of Contents for EDIRECTORY 8.8 SP1
