75
•
Digitise
– reduce the sample rate of the master mix and apply a bit-crush effect.
•
Phaser
– a 4-pole phasing effect to the master mix with a tempo-synced LFO. The LFO depth
may be customised, and feedback may be introduced
•
Vinyl Simulation
– a Lo-Fi effect to the master mix that simulates the sound of a bad vinyl
record. Apply varying degrees of pitch-wobble, crackle, and hiss, alongside a width parameter
that cuts high and low frequencies.
Effect Latching
Pad 16 in
Grid FX View
enables a Latch function. By default it is dimly lit white; when pressed it
illuminates bright white, and any Grid FX effect pad now selected will remain active until either it, or
the Latch button, is pressed again. Note that when disabling an effect directly (i.e., not via pressing
the Latch button), the effect will be disabled upon release.
When latching is enabled, multiple effects will be latched on when they are selected, however, only
one effect of each of the seven types may be latched at any one time.
The Latch state for each effect type is saved with the Project, so that some or all effects can be made
active immediately on loading the Project.
Using Grid FX with external audio
Audio signals applied to the external audio inputs
5
will be processed by Grid FX. While monitoring
is enabled in
Sample Record View
, incoming audio will be routed through Grid FX (in stereo). This
allows Circuit Rhythm to be used as a stereo FX unit. Furthermore, with resample enabled in
Sample
Record View
, Grid FX active during sample recording will be committed to the recorded sample as
heard.
MIDI control of Grid FX
Enhanced control of Grid FX parameters is possible using external MIDI control, e.g., from a
MIDI controller or sequencer. Full details are available in the separate document
Circuit Rhythm
Programmer’s Reference Guide
, which may be downloaded from
.
Summary of Contents for Circuit Rhythm
Page 1: ...1...
Page 21: ...21 After boot up the grid display will change to something like that shown below...
Page 95: ......
