26
Blocking and Unblocking Devices
The
Connected Devices
list includes a
Block
button for each connected device except your own. Use
it to disconnect a device and prevent it from reconnecting. The blocked device then appears below
in the
Blocked Devices
list.
Note that devices in the Blocked Devices list are not connected and therefore do not have an IP
address. Instead, they are identified by name and MAC address.
Select
Unblock
to unblock a previously blocked device, freeing it to connect again. The unblocked
device is deleted from the
Blocked List
and will reappear in the
Connected Devices
list when it
connects.
Connected Devices - Block/Unblock Buttons
Data Usage
Use the
Data Usage
page to set data counters and thresholds to match that of your service provider
data plan. Later, you can refer to this page to see:
•
An estimate of data used so far in the current billing cycle.
•
The number of days remaining in the billing cycle.
•
The date on which the billing cycle was last reset.
To set data usage settings:
➊
Contact your service provider, if necessary, to determine information about your data plan.
➋
Set
Monthly usage limit
to the maximum amount of data your plan allows.
➌
Use
Set a usage threshold alert
to specify a level of data used that will trigger an alert. When
this threshold is reached, a message appears at the top of the MiFi M100 Home Dashboard
when you first open it.
➍
Set
Cycle start date
to the day of the month on which your service provider’s billing cycle
begins.
➎
Select
Save Changes
.
