NovaJet PROe Series
14 Quick Start
Note: Visually inspect each cartridge before filling it. Make sure the blue tape is
intact on the jet area of the cartridge. Do not remove tape at this time! Inspect
the IC chip on the cartridge. Make sure it is secure and in approximately the
location shown on the following figure. If any cartridge is damaged, use one of
your spare cartridges in its place and contact your authorized ENCAD distribu-
tor/dealer for return/replacement of the defective cartridge.
➪
➪
➪
➪
➪
To fill the ink cartridges
Note: Before starting, you may want to have paper towels handy and wear
disposable gloves (included in the accessory box).
!
Leave the blue tape over the jet area until you are ready to prime the jet
plate.
!
Do not touch the jet area or the flex contact area of the ink cartridge.
1
Remove the cap on the squeeze bottle.
2
Insert the needle of the squeeze bottle into the hole on the top of the empty ink
cartridge. Slowly push it down until it bottoms out, then retract it by approximately
1/8".
3
Slowly press the bellows, dispensing all of the ink into the ink cartridge.
4
Recap the squeeze bottle.
5
Hold the PROe series ink cartridge upright so no ink comes out of the top
and install the cartridge into the carriage.
