13
WORK PIECE CLAMP
The wood clamp is designed to keep your
work piece stable whilst cutting (Fig. 13).
Ensure your work piece is securely in place
before cutting.
OPERATION
TURNING ON AND OFF
1. To turn the Mitre Saw on, depress and
hold the on/off switch (Fig. 14).
2. To turn the Mitre Saw off, release the on/
off switch.
OPERATING THE LASER BEAM
The laser can be used as a guide when
cutting and can be adjusted to suit your
personal preference. To turn the beam on,
press the laser light on/off switch (Fig. 15).
SPEED SELECTION SWITCH
The speed selection switch it located on
the top of the handle assembly. Refer to the
table below for selecting the best speed for
your requirements.
SPEED
MATERIAL
I (3000
-1
)
Mild steel plates, angles and
tubes. All non-ferrous metals
such as aluminium, copper etc.
II (5000
-1
)
Timber and all timber products
such as plywood, chipboard,
hardboard etc. Most plastic
materials. Kitchen worktops etc.
Fig.13
Fig.14
On/off switch
Fig.15
Laser on/off
switch
Fig.16
Speed
selector
Summary of Contents for NG-2102SPD
Page 24: ...www spoton com au...
