Nova gear NG-2102SPD, Instruction Manual

Page: 17 / 24

17
a dry (test) run of the cutting operation to
check that there are no problems and
everything is correctly adjusted.
NOTE: Before performing a cut, ensure the
blade is at full speed. Failure to do this will
cause your blade to become blunt and
cause the blade to lock-up.
7. Turn on the Mitre Saw, wait for the blade
to reach full speed and then lower the
cutting head whilst pushing the safety
guard release lever so the blade starts
cutting the work piece.
8. Release the on/off switch when the cut is
complete and allow the blade to
stop rotating before raising the cutting
head. This is required for safe operation
of the unit to prevent personal injury.
SLIDE CUT
These machines are equipped with a
sliding carriage system (Fig. 21) to assist
with cutting wide pieces.
Loosening the sliding carriage lock
will release the carriage and allow
the cutting head to move forwards and
backwards. The saw blade is lowered into
and through the front edge of the work-
piece and then pushed to the rear of the
machine to complete a cut.
1. Position the work-piece on the table and
against the fence and secure with clamp(s)
as appropriate.
2. Loosen the slide lock screw (Fig. 22).
3. Grasp the cutting handle and pull the
cutting head forward until the arbor (centre
of saw blade) is directly over and above the
front edge of the work-piece.
4. Operate the ON/OFF trigger switch and
allow the saw blade to reach full speed.
5. Operate the safety guard release lever to
release the cutting head.
6. Push the cutting handle all the way down
and cut through the leading edge of the
work-piece.
7. Gently push the cutting handle backwards
towards the fence completing the cut.
Fig.21
Fig.22 Slide lock