12
WORK PIECE SUPPORT BAR
Work piece supports are located on the left
and right side of the machine. The work
piece support slides into the two holes
found at the base of the machine. Use
the adjustment knobs (Fig. 12) to set the
support bars to the required length.
RETRACTABLE SAFETY GUARD AND LOCK
The retractable safety guard provides
protection from both sides of the blade (Fig.
9). It retracts over the upper fixed blade
guard as the saw is lowered into the work
piece.
When in operation, before lowering the
cutting head the safety guard release lever
must be released. This is done by pressing
the safety guard release lever (Fig. 10).
DUST BAG
The dust bag fits over the dust extraction
port.
NOTE:
The dust bag is only for use when
cutting wooden and plastic materials. It
should not be used for cutting metals or
any metallic type materials. Always remove
the dust bag before cutting metal materials.
NOTE:
Empty the dust bag when it becomes
2/3 full. It is advised to wear a dust mask
when disposing of the dust materials.
To install or remove the dust bag follow the
procedure below:
1. Squeeze the dust bag clamp and place
the opened hole over the dust extraction
port (Fig. 11).
2. Release the dust bag clamp.
3. To remove, squeeze the clamp and pull
the bag off taking care not to spill the
contents.
NOTE:
A workshop vacuum may be attached
to the dust extraction port if required. Follow
manufacturers instructions.
Fig.9
Fig.10
Safety guard
release lever
Fig.11
Fig.12
Summary of Contents for NG-2102SPD
Page 24: ...www spoton com au...
