Nova gear NG-2102SPD, Instruction Manual

Page: 9 / 24

9
SET-UP AND ADJUSTMENTS
3. The Mitre Saw has been shipped with the
cutting head in the locked down position. To
release the cutting head, push down on the
operating handle, pull the head locking pin
(Fig. 2) and gently raise the cutting head.
TRANSPORTATION
Ensure the Mitre Saw is turned off and
disconnected from the power source before
transporting. Lift the Mitre Saw only when the
cutting head is in the locked down position.
Only lift the Mitre Saw by the carry handle or
outer castings. Do not lift the Mitre Saw using
the retractable safety guard or the operating
handle.
BENCH MOUNTING
The base of the Mitre Saw has four bench
mounting holes that can be used to mount it
to a workbench or mitre saw stand (Fig. 3).
1. Mount the Mitre Saw onto a workbench or
mitre saw stand. Ensure the surface is level
and balanced.
2. Use four screws and bolts (not included)
to secure the Mitre Saw to the workbench or
mitre saw stand.
NOTE: If required, the Mitre Saw can be
mounted onto a 18mm piece (or thicker) of
plywood which can then be clamped to the
work bench or mitre saw stand. This
UNPACKING
1. Remove the packaging materials from
around the Mitre Saw and remove all parts
from the packaging.
2. Using the carry handle (Fig. 1), carefully lift
the Mitre Saw from the packaging and place
it on a level work surface.
Warning: Do not lift the Mitre Saw
whilst holding on to the guards. Use
the carry handle.
!
Fig.1
Fig.2
Head locking pin
Fig.3