Nouveau Contour iQ, Manual

Page: 31 / 36

31 EN NC iQ
FAULT/
MESSAGE
FAULT CAUSE ACTION TAKEN
The control
unit auto-
matically
shuts off
during oper-
ation.
The power
supply
has been
disconnected
or a fault has
occurred at
the control
unit.
The power supply
plug is not properly
connected.
E Check the connection of the power
supply plug to the control unit (see
chapter 5.2 "
Connecting the hand-
piece “ on page 18).
E Check the mains power supply to the
workstation.
When the power supply has been con-
nected:
E Switch the control unit into standby
mode and wait about 30 seconds (see
chapter 6.1 "
Switching the control
unit into operating or stand-by mode
“ on page 24).
E Switch the control unit back into oper-
ating mode.
To remove further function disturbances:
E
First disconnect all components, such as the handpiece and the power supply unit from
the control unit.
E
Check all connections and reassemble all the components.
E
Recheck all device functions.
In the event of continued function disturbances and for questions or complaints, please con-
tact the authorised dealer.
11 WARRANTY DECLARATION
This device is a high-quality product.
The statutory warranty of 2 years applies to this product for malfunctions attributable to ma-
terial defects or processing faults.
We guarantee sterility of the needle modules for 5 years, as long as all packaging stays
sealed and undamaged in accordance with transport and storage conditions. In the event
of a warranty claim for a needle module, please indicate the lot number printed on the label.
We cannot assume any liability for the following damages:
O
Damage and consequential damage caused by the improper use or non-compliance with
the operating instructions.
O
Any damage caused by ingress of liquids or debris into the inside of the handpiece, the
control unit or the power supply plug