Nouveau Contour iQ, Manual

Page: 18 / 36

NC iQ 18 EN
5.1 Setting up the control unit
CAUTION
Restricted operation due to electromagnetic interference
Portable and mobile RF communication devices, such as mobile telephones or WLAN rout-
ers can affect device function by emitting electromagnetic radiation. The safe operation of
the device can then no longer be guaranteed.
E
Place the appliance in such a way that the recommended safety distance from possi-
ble sources of interference is always observed. Information about recommended safety
distances may be found in chapter 11.2.3 "Recommended safety distances for portable
and mobile RF communications equipment“ on page 32.
E
Avoid possible sources of interference by not operating any portable or mobile radio
devices in the vicinity of the device.
E
Make your customers aware of this risk of interference sources.
E
Set up the control unit on a clean, firm and level support surface. This device should never
be set up and operated beneath other devices.
5.2 Connecting the power supply plug
The device may only be operated with the plug-in power supply specified on the name plate
of the device. The mains voltage must be the rated device voltage as it is indicated on the
plug-in power supply name plate.
E
If the scope of delivery did not contain a country-specific adapter, please contact your
authorised dealer (also see chapter 10 "In the event of questions and problems“ on page
30).
To remove the currently connected country-specific adapter, if necessary:
E
Pull and hold back the holding bracket for the adapter and simultaneously lift out the
country-specific adapter from the cavity in the power supply plug.
Fig. 1: Remove the country-specific adapter
How to insert the desired country-specific adapters:
E
Insert the country-specific adapter into the power supply plug recess as shown below.