INA 15092:I 05/30/01
67
2.2.1 INA ACS Programming Example
In the example below, the INA's network node address is N4. N4 annunciator points A1P1, A1P2, and A1P3 are shadow
annunciator points. AM2020/AFP1010 and AFP-300/400 FACPs at Node 5, Node 6, and Node 7 are included in the INA's
group .
A1P1 on Node 4 mimics A1P1 on Node 5. A1P2 on Node 4 mimics A1P2 on Node 6. A1P3 on Node 4 mimics A1P3 on Node
7. Programming for this example is as follows:
N5A1P1 is programmed with an annunciator point Type ID
N4A1P1 is programmed with Type ID NAPT
N6A1P2 is programmed with an annunciator point Type ID
N4A1P2 is programmed with Type ID NAPT
N7A1P3 is programmed with an annunciator point Type ID
N4A1P3 is programmed with Type ID NAPT
In the above example:
The INA shadow annunciator point address must be the same as the address of the FACP annunciator point that
the programmer wishes to mimic.
The INA shadow annunciator points are mapped to the FACP points (Nodes 5, 6 and 7) through Full Point
Programming with type NAPT or through network mapping (NMAP) under Partial Point Programming.
The FACP annunciator point being mimicked by the INA shadow annunciator point must be installed in FACP
programming, but an annunciator module does not have to be physically installed at the FACP.
If a device or zone activates the FACP annunciator point through annunciator point mapping, the corresponding
shadow INA annunciator point will also be activated.
INA ACS annunciator points can be mapped to AFP-200 and AFP-300/400 zones. INA ACS points cannot mimic AFP-200
ACS points and only AFP-300/400 ACS points can be mapped to the special annunciators. INA ACS points are mapped to
AFP-300/400 zones during full-point programming with Type ID NZON. INA ACS points are mapped to AFP-200 CCBE
Zones through Full Point Programming or under Partial System Programming with the Type ID NZON. Note that only one
non-alarm device can be mapped to a CCBE zone on an AFP-200 when the zone is mapped to an INA ACS point. When the
AFP-200 or AFP-300/400 zones are activated, the INA ACS point mapped to that zone is also activated. For more informa-
tion on AFP-200 and AFP-300/400 zones, refer to the appropriate manual.
ACM-16AT annunciators which operate with an AMG may also contain shadow annunciator points programmed with Type
ID NAPT. An activated ACM-16AT shadow annunciator point activates the AMG voice evacuation. When employing
INA shadow ACM-16AT/AMG shadow annunciator points, do
not
physically install the annunciator or AMG at any other
node in the INA's group.
Note:
For more information on annunciator mapping on the AM2020/AFP1010, refer to Chapter Three of Document
15088. For more information on shadow annunciator points, refer to Section 1.1.2 of this chapter. For more information
on annunciator mapping on the AFP-300/400, refer to Appendix A of Document 50253.
www.PDF-Zoo.com
