66
INA 15092:I 05/30/01
1=TYPID - Type ID
D }X3X1X
Option 1 from the Partial Point Programming menu allows the programmer to change the software type ID of an annunciator
point connected to the network.
PRESS 1=PSYS,3=PPRG,4=FPRG,5=REMV,6=PSWD,7=MSG : 3
PRESS 1=TYPID,2=NMAP : 1
ENTER@AXXPYY@FOR@PT.@CHANGE@(BCKSPC@TO@ABORT)@@@@@@@@@@@@@@@@@@@@@@@@@: A3P14
ENTER@TYPE@ID@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@: ARES
For a description of software type IDs, refer to Appendix B of this document.
2=NMAP - Network Mapping
D }X3X2X
Option 2 from the Partial Point Programming menu allows the programmer to change the network zone or FACP mapping of
the entered annunciator point. Specific AM2020/AFP1010 and AFP-300/400 ACS points may be mimicked by an INA ACS
point. On the AFP-200, INA ACS points may only be mapped to zones.
NOTES:
1) Only type NZON annunciator points can be mapped to a network zone.
2) Annunciator points can only be mapped to a single network zone.
3) NAPT points can be mapped to only one node, therefore they will mimic only one local annunciator point.
Example for Network Zone Annunciator map programming:
PRESS 1=PSYS,3=PPRG,4=FPRG,5=REMV,6=PSWD,7=MSG : 3
PRESS 1=TYPID,2=NMAP : 2
ENTER@AXXPYY@FOR@PT.@CHANGE@(BCKSPC@TO@ABORT)@@@@@@@@@@@@@@@@@@@@@@@@@: A3P15
ENTER@NYYYZXXX@FOR@MAPPING@TO@NETWORK@NODE@AND@ZONE@@@@@@@@@@@@@@@@@@ : N3Z20
Example for Network Shadow Annunciator map programming:
ENTER@AXXPYY@FOR@PT.@CHANGE@(BCKSPC@TO@ABORT)@@@@@@@@@@@@@@@@@@@@@@@@@@: A3P16
ENTER@NODE@ADDRESS@NXXX@FOR@NETWORK@ANNUNCIATOR@POINT@@@@@@@@@@@@@@@@@@: N3
When programming a shadow annunciator point, make sure that the INA shadow annunciator point has the same
address as the annunciator point on the corresponding node. In the example above, shadow point A3P16 on the INA,
mimics A3P16 on Node 3. For more information on shadow annunciator points, refer to Section 1.1.2 of this chapter,
Programming Annunciator Points.
www.PDF-Zoo.com
