Nothern Industrial tools 331804, Owner'S Manual

Page: 7 / 15

6
The red light will illuminate when the charger commences charging.
• The battery will take 1 hour to charge. Once charged the red light will fade and the green
light will once again illuminate.
• Once the battery has charged the charger will cease charging but as a safety precaution,
removing the battery from the charger and switching off at the mains is recommended.
Removing the battery from the charger
Depress the battery pack release buttons on both sides of the battery and simultaneously
slide the battery backwards away from the charger.
Note: If LED on the charger fails to illuminate
• Check the charger is securely plugged into the wall outlet and is switched on.
• Check the battery is firmly seated into the charger.
Important charging notes
• The charger and battery may become warm to touch while charging. This is a normal
condition, and does not indicate a problem.
• Use the charger at normal room temperatures whenever possible. To prevent overheating,
do not cover the charger and do not charge the battery pack in direct sunlight or near
heat sources.
OPERATION FOR IMPACT DRIVER
On/off switch
To turn the impact driver on, depress the trigger switch, to turn off, release the trigger switch.
Speed control
The speed can be varied from 0 to maximum, depending on the pressure applied to the trigger.
This way you can select the best possible speed for the job being done.
Changing direction of rotation
With the incorporated reversing switch installed in your tool the direction of rotation can be
changed with the forward / reverse lever. To engage the tool into the forward setting, depress
the right side of the lever into the tool. To engage the tool into the reverse setting, depress
the left side of the lever into the tool.
The switch can be locked off by pushing the forward / reverse lever into the middle of both
forward and reverse positions.
Do not change the direction of rotation while the sleeve is still in motion.
Installing power bits
Ensure the tool has been switched off and the battery removed prior to installing bits.
Pull the sleeve forward and then insert the power bit into the sleeve as far as possible. Once
the bit has been inserted, release the sleeve. The sleeve will spring back to its original posi-
tion locking the power bit in place. Pull the power bit to ensure it is locked in the sleeve prior
to operation.