10
3 Assembly and commissioning
The machine is delivered fully equipped. It is ready for operation after assembly the diamond blade,
the blade guard and the guide-a-cut, and after connection to the appropriate power supply.
3.1 Tool assembly
Only CLIPPER continuous rim blades with a maximum diameter of 200 mm can be used with the
TT200EM.
All tools used must be selected with regard to their maximum permitted cutting speed for the
machine’s maximum permitted rotation speed.
Before mounting a new blade into the machine, switch off the machine and isolate it from the main
source of electricity.
To mount a new blade, follow these steps:
•
Loosen the two screws on the side of the blade protection remove the front cover.
•
Loosen the hexagonal nut which holds the removable outer flange on the blade shaft with the
19mm wrench and the special tool to lock the flange.
•
Remove the outer flange.
•
Loosen the two screws holding the blade guard support and remove it from the machine.
•
Clean the flanges and blade shaft and inspect for wear.
•
Mount the blade on the flange ensuring that the direction of rotation is correct (check with the
arrow on the blade guard). Wrong direction of rotation blunts the blade quickly.
•
Replace outer blade flange.
•
Tighten hexagonal nut.
•
Retighten the two screws holding the front cover, and reassemble the blade guard support on
the table.
The blade bore must correspond exactly to the diameter of the blade shaft. Cracked or damaged
bore is dangerous for the operator and for the machine.
3.2 Guide-a-cut assembly
To assemble the guide a cut:
•
Put the guide a cut on the table.
•
Use the handle on the side of the guide-a-cut to pinch it on the table
3.3 Electrical connections
Check that,
•
the voltage/phase supply corresponds to the information indicated on the motor plate.
•
Available power supply must have ground connection in conformity with safety regulations.
•
The connecting cables should have at least a 2.5mm
2
-section per phase.
3.4 Starting the machine
Press the green button to start the machine. Press on the red button to stop the machine. The red
button is also the emergency switch.
