Norton Clipper CE414-350, Owner'S Manual

Page: 19 / 27

ENGLISH 19
Always observe all safety instructions and all information in this document before using this
machine!
Check list for use (keywords only!) ...........................................................

Before start-up:
– Power tool in an operationally safe condition! ................................. Operating instructions complete
– Prescribed work clothes ................................................................. Chap. 3.3, page 9
– Working area inspected and secured ............................................. Chap. 3.2, page 8, and
Chap. 3.7, page 9
– Blade installed Correctly ................................................................. Chap. 5.1, page 17, and
Chap.
Error! Reference source
not found.
, page 19
– Blade Guard in best position .......................................................... Chap. 5.2, page 18

During work – generally safe work: ....................................................... Operating instructions complete
– Inspecting the working environment ............................................... Chap. 3.7, page 9,
Chap. 6.2, page 20, and
Chap. 6.3, page 21
– Water connection for wet cutting ..................................................... Chap. 5.3, page 15
– Proper cutting technique ................................................................ Chap. 6.3, page 21,
Chap. 6.4, page 21, and
Chap. 6.5, page 21

After work: ............................................................................................ Operating instructions complete
– Cleaning and care .......................................................................... Chap. 0, page 22
– Replacing the carbon brushes ........................................................ Chap. 7.2, page 20
– Using the flip stand ......................................................................... Chap. 7.3, page 22
–
Maintenance ................................................................................... Operating instructions complete
Only use Diamond Blades that correspond to the standards EN 12413 and EN 13236
and that are perfectly undamaged. The approved maximum speed of the cutting disc
must be
≥ 4,450 rpm (min
-1)
.
For cutting of metals (hot cutting) and cutting of mineral based materials – block, brick, concrete,
stone (cold cutting), different cutting discs are offered. Use only the blades that are approved for the
material to be cut.
Diamond cutting blades are only approved for cutting mineral based materials. When installing the
diamond blade, always observe the rotating direction indicated on the diamond blade; otherwise, the
cutting effect will reduce quickly from diamond loss.
Rotating direction of the blade in the installation process see:

Chap. 5.1, page 17
Synthetic resin based thin wheel cut of blades must not be exposed to moisture. The water
connection for wet cutting must not be used when using synthetic resin cut off blades. Synthetic
resin blades must not be used in high humidity or in rain. Only use synthetic resin blades until the
end of the best-before date imprinted on the blade blotter or shipping box.
The power tool's spindle is designed for cutting discs with an inner bore of 20 mm.
Blades with an 1" inner bore must only be installed with the spindle adapter provided with the
CE414-350. Using other spindle adapters may not allow the blade to be properly secured to the
machine.
Installation of blades with 1" inner bore see:
 Chap. 5.1, page 14
Blades with other inner bores must not be installed!
6 Power Tool Use
6.1 Blades