Norton Clipper CE414-350, Owner'S Manual

Page: 17 / 27

ENGLISH 17
The cutting discs used must correspond to the specifications from chap. Error! Reference
source not found. on page Error! Bookmark not defined. !
The power tool uses a 20mm spindle is paired with an adapter blade adapter for use with 1
inch (25.4mm) bore cuttings blade. The components are assembled as shown below, along
with the universal wrench (e) included with the power tool to remove the blade bolt (d).

For blade installation, the power tool must be put securely on the ground and unplugged. With the
power tool handle facing you place left arm on the power tool body and use the correlating hand
to press the spindle lock button (7) shown below. With the free hand use the universal wrench (e)
to turn the blade bolt (d) clockwise, or away from you. Apply slight downward force from the left
arm onto the motor body to keep the tool from moving, if it should:

Remove the blade bolt (d), its washer (c) and outer flange (b). Install the cutting disc (1), and
make sure the bore of the disc slides onto the adapter (a) all the way. Also locate the spinning
direction of the disk and match it with the diagram above’s note. If you are facing the blade guard,
facing the side you are installing the cutting disc from. The disc must rotate clockwise.

Once the cutting disc (1) is properly seated, reinstall the outer flange (b), washer (d) and blade
bolt. Press the spindle lock button (7) again and this time use the universal wrench (e) to turn the
blade bolt counter-clockwise until tight.
5 Preparing for Use
5.1 Installing/Removing the Cutting Disc
1
a
b
c
d e
7
Rotating direction
of the cutting disc