TVIPTZ30XIR
·
Quick Start Guide
1
1
Installation
Before you start:
Check the package contents and make sure that the device in the package is in good condition and
all the assembly parts are included.
There are several ways to install the analog speed dome. The wall mounting is taken as an example
below.
1.1
Connecting the Cables
Please turn the power off before connect the cables.
The cable interfaces of speed dome are shown in following figure. The cables are distinguished by
different colors. The labels attached on the cables are for identification.
RED AC24V
YELLOW/GREEN GND
BLACK AC24V
①
YELLOW R485-
ORANGE R485+
②
Video Output
Yellow&Green
Yellow
Orange
Black
Red
①
②
Figure 1-1
Cables of 7-inch IR Speed Dome
1.2
Settings
1.2.1
7-inch IR Speed Dome Settings
Two DIP switches
SW1
and
SW2
are for setting the speed dome address, baudrate, protocol, etc.,
with value ON=1 and OFF=0. The switch label is on the back of the SWITCH cover as shown in
Figure 1-2.
Each number of the switch represents a DIP value, ranging from 1 to 8 for the lowest to highest.
Summary of Contents for TVIPTZ30XIR
Page 1: ......
