2.3 POSSIBLE PROBLEM… ...… … … … … … … … … … … … … … … … … … … ..
Even if the appliance is used correctly, some problems may arise for various reasons.
The table that follows mentions some possible problems and some possible causes.
In case of problem we control first if the electrical supply to the machine is right
or not.
POSSIBLE PROBLEM
POSSIBLE CAUSES
Machine is not operating
Check if there is damages to 1)all heating
elements 2)the edge of cord connected with
the thermostat or connector strip.
Heating element is not
operating
Check if there is to 1)the heating element 2)the
edge of supply cord connected with heating
element.
Light is not operating
Check if there is damages to 1)Lamp 2)switch
on-off
Non normal temperature
Possible temperature deviation of thermostat.
2.4 REPLACEMENT OF ELECTRICAL ELEMENTS.........................................
To replace the upper heating element remove the right side cover of the appliance.
Release the wires and remove the heating element holding screws inside chamber.
For the lower heating element remove the grill plate.
The lighting lamp is replaced from the inside of the chamber after removing lamp’
s lid.
For the thermostats, indicating lamps and lighting switches remove the right side cover
of the appliance.
CUT OFF THE POWER SUPPLY BEFORE COVER REMOVAL.
2.5TRAINING......................................................................................................
The personnel who are to install and connect the appliance must train the users
appropriately so that they can handle the operation and safety measures of the
appliance.
ATTENTION !!!
•
Check that main voltage in your working area is suitable for the settings on the label
and that the appliance is properly earthed.
•
Before any service activity takes place or any parts are replaced on the appliance,
make sure that pains supply is turned off.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR ACCIDENTS
AND DAMAGE CAUSED TO PERSONS, ANIMALS OR PROPERTY DUE TO
NONCOMPLIANCE WITH THESE INSTRUCTIONS.