Installing Skid-Resistant Pads
Installing Between Two Walls
Step 1:
To help protect floors, ensure the skid-resistant pads are on
the bottom of the gate panels. Clean and dry the panels prior
to installing the pads. Remove a single pad from the release
paper as shown in Figure 1. Place the adhesive side of the
pad onto the bottom edge of the gate panel approximately
2” from the center of each hinge, as shown in Figure 2.
Repeat steps for each of the remaining pads. Maximum
skid-resistance will be maintained by cleaning the bottoms
of the pads periodically with a water-dampened clean cloth.
FIGURE 1
FIGURE 2
Page 3
Step 2:
Position both of the preassembled wall mounting
connectors/wall hinges, vertically so the wall hinge
pins are facing upwards on the wall, and the mounting
connector is as close to the floor as possible. Mark the
top of each wall hinge. See Figure 3.
Step 3:
Separate the mounting connectors from the wall
hinges by pressing inward on the locking boss located
in the center of the wall hinge. Lift up on the
connectors to free them from the wall hinge. See
Figure 4 for removal from wall hinge.
Step 4:
To attach the wall hinge to the wall, align the top with the
mark drawn in Step 2. Mark the top hole and pre-drill a
1/8” pilot hole. Attach the top of the wall hinge in place
with a screw. Proceed down the hinge and install a screw
into each screw hole with screws provided.
Step 5:
Attach the mounting connector side A to panel 1 by
setting opening A over Pin B, push down in order to
slide Pin C into the slot of Cylinder D. See Figure 5.
Step 6:
Attach the mounting connector side B to panel 2 by
setting opening A over Pin B, push down in order to
slide Pin C into the slot of Cylinder D. See Figure 6.
WARNING:
Do not mount gate hinges into sheetrock or
plaster. Hardware is included for use in solid materials,
such as wood or metal. Never mount the gate at the top
of the stairs.
Note:
This gate is to be used in openings 38.5” to 201”
wide. When setting up as a barrier, maximum number of
panels is six.
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
Wall
Mark
Here
Wall
Mark
Here
Floor
Pin C
Pin B
Opening A
Opening A
Slot in
Cylinder D
Slot in Cylinder D
Pin B
Pin C
FIGURE 7
Step 7:
Attach the mounting connectors, that are now
attached to the panels, to the wall hinges by
aligning the horseshoe shaped hoops on one
side of the gate over the pins on the wall hinges
to set the gate in place. See Figure 7.
NOTE: Always lift up on the end panels to
ensure that the gate is properly secured and
locked in place.
Removal from Wall Hinge
To remove the gate from the wall hinge, press on
the locking boss located on the center of the wall
hinge (See Figure 8), and lift the panel itself until
the gate rib clears the locking boss.
FIGURE 8
Wall
Hinge
