Assembly and Initial Set-Up
12
Step 2. Assembly
You must assemble your pressure washer before it can be used. Refer to
Figure 4
and follow the
steps listed below:
Step 1.
Install handle with four (4) 5/16-18 x 2” Flange Bolts through Base and Handle and
secure with four (4) 5/16-18 Flange Nuts and Washers.
Step 2.
Install one (1) Gun Hook into the left side of the Handle using two (2) 5/16-18 Flange
Nuts.
Step 3.
Install Hose Hook into right side of Handle using two (2) 5/16-18 Flange Nuts.
FIG02320
Install Grommets and
Nozzles into Holes in
Control Panel
Install One (1) Gun
Hooks into Left Side of
Handle using Two (2)
5/16-18 Flange Nuts
Install Hose
Hook into Right
Side of Handle
using a (2) 5/16-
18 Flange Nuts
Install One (1) Gun Hook
on Left side of Base
Lift Back of Unit by
Handle to Install Rear
Wheels, then Lift
Front of Unit to Install
Front Wheels
Install
Wheel onto
Axle
Fasten Wheel with
Retainer using a hex
wrench
Note:
It is Recommended that
Two People Lift this Unit
While a Third Slides the
Wheels onto the Axle
Install Four (4)
Flange Bolts through
Base and Handle and
Secure with Four (4)
5/16-18 Flange Nuts
and Washers
Figure 4
