Nortel Web OS 10.0, Application Manual

Page: 299 / 482

Web OS 10.0 Application Guide
Chapter 12: Global Server Load Balancing
n
299
212777-A, February 2002
3. On the California switch, define the domain name and host name for each service hosted
on each virtual server.
In this example, the domain name for the Foo Corporation is “foocorp.com,” and the host
name for the only service (HTTP) is “www.” These values are configured as follows:
To define other services (such as FTP), make additional hostname entries.
4. On the California switch, turn on GSLB.
5. Apply and verify the configuration.
Examine the resulting information. If any settings are incorrect, make and apply any appropri-
ate changes, and then check again.
6. Save your new configuration changes.
Task 4: Configure the Basics at the Denver Site
Following the same procedure described for California (see “Example GSLB Topology” on
page 294 ), configure the Denver site as follows:
1. If the Web OS BBI is to be used for managing the Denver switch, change its service port.
>> Real server group 1# ../virt 1
(Select virtual server 1)
>> Virtual server 1# dname foocorp.com
(Define domain name)
>> Virtual server 1# service 80/hname www
(Define HTTP host name)
>> Virtual server 1# ../gslb (Select the GSLB Menu)
>> Global SLB# on (Activate GSLB for the switch)
>> Global SLB# apply
(Make your changes active)
>> Global SLB# cur
(View current GSLB settings)
>> Global SLB# /cfg/slb/cur
(View current SLB settings)
>> Layer 4# save (Save for restore after reboot)
>> # /cfg/sys
(Select the System menu)
>> System# wport 8080
(Set service port 8080 for BBI)