56
Configuring the Secure Router 4134 for remote access
Prerequisites
•
Ensure you have the supplied console cable.
•
Ensure you have the supplied female DB-9 to RJ-45 adapter if you
require it for connection to your terminal or PC.
•
Ensure you have the Secure Router 4134 securely installed in the
equipment rack.
•
Ensure you have powered up the terminal or PC.
Procedure steps
Step
Action
1
Set the terminal protocol as follows:
a
9600 baud
b 8 data bits
c
1 stop bit
d no parity
e
flow control: None
2
Insert the male RJ-45 connector in the console port on the rear
panel of the Secure Router 4134.
3
Connect the female DB-9 to RJ-45 adapter to the opposite end
of the console cable, if necessary.
4
Insert the RJ-45 or female DB-9 connector (dependent on your
equipment) in a terminal or PC.
5
Power up the Secure Router 4134.
--End--
Establishing remote access
The first time you log on to the Secure Router 4134 CLI, you perform initial
configuration such as the following:
1.
Configure the IP address for the management port.
2.
Configure the next hop (gateway IP address).
3.
Verify a successful connection.
4.
Enable remote access.
You can enable SSH or Telnet for remote connections.
Nortel Secure Router 4134
Quick Start
NN47263-100
02.01
Standard
18 February 2008
Copyright © 2007, 2008 Nortel Networks
.
Summary of Contents for Secure Router 4134
Page 69: ......
