52
Installing the Secure Router 4134 chassis and hardware components
Powering up the router
Use the procedure in this section to power up your Secure Router 4134.
Prerequisites
•
Ensure all installation procedures are complete.
•
Ensure an operator console is connected to the Secure Router 4134.
•
Ensure the Secure Router 4134 is connected to a power source.
Procedure steps
Step
Action
1
For an AC power supply, press the rocker switch located on the
power supply to the on position ( | ).
2
On a DC power supply, ensure the DC power source is on.
3
Verify that the power supply status LED for each power supply is
green.
4
Verify that the fan status LED is green.
5
Verify that the air flows from the cooling fans through the vents of
the chassis.
The fan tray red (fail) LED can illuminate briefly while the fans
power to operational speed.
--End--
If status LEDs do not illuminate green, see Nortel Secure Router 4134 —
Troubleshooting (NN47263-700).
Verifying a successful installation
Use the information in this section to verify that you have successfully
installed the Secure Router 4134 and its components.
If any LED behavior indicates failure or is suspect, see Nortel Secure
Router 4134 — Troubleshooting (NN47263-700).
In a normal power-up sequence, the following events occur:
1.
When you power up the router, the fans start and the Secure Router
4134 performs a self-test.
2.
At the successful conclusion of the self-test sequence, LED activity
begins. The following table describes LED behavior at power-up.
Nortel Secure Router 4134
Quick Start
NN47263-100
02.01
Standard
18 February 2008
Copyright © 2007, 2008 Nortel Networks
.
Summary of Contents for Secure Router 4134
Page 69: ......
