109
Appendix C: Testing the WLAN Handsets 2210/2211
Appendix C: Testing the WLAN Handsets 2210/2211
Introduction
Verify proper registration and operation of each wireless handset by performing the following tests
on each wireless handset in an active wireless area.
Testing calls and features
1
Power on the WLAN handset by pressing
Power On/Start Call
.
A series of messages display as the WLAN handset accesses the system. The WLAN handset
displays the user extension or displays dashes if no extension is programmed. Any error
messages clear.
2
Press the
Power On/Start Call
key.
The extension number is replaced by information from the BCM and dial tone is heard.
3
Place a call and listen to the audio quality.
End the call by pressing the
Power Off/End Call
key.
4
Place a call to the WLAN handset and verify ring, answer, clear transmit, and clear receive
audio.
5
Use the
FCN
key to verify all programmed features on the WLAN handset.
6
Press the
Power On/Start Call
key.
Any line indicators turn off and the extension number display returns.
Testing signal strength with the WLAN handsets
1
Test signal strength in the covered area by putting a WLAN Handset 2210/2211 in Site Survey
Mode.
Refer to
“Site Survey mode” on page 113
.
2
Walk the entire coverage area while viewing the display.
The
FCN
key toggles between three coverage modes:
Summary of Contents for MOG6xx
