Nortel Contivity 100, Setting Up

Page: 59 / 78

Chapter 5 LEDs: support and diagnostic functions 59
Setting Up the Contivity 100 Unit
LEDs 1 through 8 and the Power LED during operation
After the power-up sequence is complete, the LEDs indicate status and activity
during operation as shown in
Table 11 .
Table 11 LED status and appearance during operation
LED # Color Appearance Meaning
Power Green Solid Unit has electrical power and is turned on.
Power Green and
Amber
Solid Green and
Flashing Amber Unit is updating flash memory. DO NOT TURN
THE UNIT OFF until the Power LED returns to
green.
1-8 Amber Solid Power voltage selector switch is set to 230 but
the power cord is plugged into a 110 voltage
plug.
1 Green Blinking Unit is operating normally.
2 Green Solid Unit is ready to service clients.
2 Green and
Amber Solid Green and
Flashing Amber Unit is communicating with clients.
2 Amber Solid Unit is ready to be configured, but cannot
service clients (normally occurs before unit has
been configured).
3-8 Green Solid Indicated interface (see Note below) is online.
3-8 Green Flashing Indicated interface (see Note below) is dialing or
attempting connection.
3-8 Green and
Amber Solid Green and
Flashing Amber Traffic is on the indicated interface.
3-8 Red Solid Indicated interface (see Note below) has failed.
Note:
The “indicated interface” is the interface associated with the
LED’s number. This information is available in the main dialog box of the
Setup program. For more information, refer to Using the Contivity Branch
Access Management Software Version 7.20.