Nortel 222, User Manual, Page: 295 / 349

Appendix H Command Interpreter 295
Nortel Business Secure Router 222 Configuration — Advanced
ipPool <index>
Select which IP pool, index is based on 1,
and inactive IP pool cannot be selected.
ipPool load <index>
Before you configure an IP pool for client
termination, you must load the specified
IP pool. Currently 3 IP pools are
supported, so the valid index is: 1~3
save
After changing the IP pool configuration,
use the save command to save the
modification to the ROM.
active
Enables or disables the loaded IP pool.
poolName
Sets the IP pool’s name.
startAddr
Sets the IP pool’s starting IP address.
subnet
Sets the IP pool’s subnet.
size
Sets the number of IP addresses in the IP
pool.
status
Displays the current runtime IP pool
status of Client Termination.
natt active <yes |
no>
Enables or disables NAT Traversal.
portSwitch
<enable |
disable>
Enables or disables Client IKE Source
Port Switching.
portNum
Sets the NAT Traversal UDP port, valid
UDP port: 1025 ~ 65535.
failover <1 | 2 | 3> <IP>
Sets the client failover IP address.
keepalive active <yes |
no>
Enables or disables client failover tuning
(keep-alive).
interval
<hh:mm:ss>
Sets the keep-alive interval, valid interval
00:00:10 ~ 23:59:59.
maxRetrans
Sets the keep-alive max retransmissions,
valid range 0~255
pfs <enable |
disable>
Enables or disables Perfect Forward
Secrecy.
idleTo <hh:mm:ss>
Sets the Idle Timeout, the valid value is:
00:00:00~23:59:59, 00:00:00 means no
idle timeout.
aicp <on | off>
Enable or disables Accept Initial Contact
Payload.
Table 73 IPSec commands
Command Description