Table J3: Start-up Readings
Mode of Operation
Heating
Cooling
Compressor
refrigerant
side
Circuit #1
Discharge pressure – PSI
Suction pressure – PSI
Discharge temperature – °F
Suction temperature – °F
Superheat – °F
Sub-cooling – °F
Site glass oil level
__ ½ __ ¾ __
F
Site glass clear
___ Yes ___
No
Amps – L1/L2/L3
Circuit #2
Discharge pressure – PSI
Suction pressure – PSI
Discharge temperature – °F
Suction temperature – °F
Superheat – °F
Sub-cooling – °F
Site glass oil level
__ ½ __ ¾ __
F
Site glass clear
___ Yes ___
No
Amps – L1/L2/L3
Gas-fired
furnace
module
___ Natural gas ___ Propane
Inlet pressure – inches w.c.
Low fire manifold pressure – inches w.c.
High fire manifold pressure – inches w.c.
Supply air inlet temperature – °F
Supply air discharge temperature – °F
Electric
heating
Stage
1
2
3
4
5
6
Amp draw – L1
Amp draw – L2
Amp draw – L3
This unit has been checked out and started according
with the above procedures and completed forms and is
operating satisfactorily.
After 24 hours of satisfactory operation, shut down the unit
and check all foundation bolts, shaft bearings, drive set
screws, valve train and terminals. Tighten where required.
Additional Comments:
_________________________________________________
_________________________________________________
Start-up
By: ______________________________________________
Date: ____________________________________________
Email: ___________________________________________
Company Name: __________________________________
Telephone: _______________________________________
Email to Tech Support (
) or
fax to 306-244-4221.
Serial Number: _____________________________________
VCES-VHC-IOM-1F – VHC-36, -42 & -50
61
