32
TS571W Installation Instructions
TS571W Installation Instructions
33
Accessories are Available From Your Retail Store
Accessories
Solar Panel (FM123)
The
Solar Panel
is a 10 watt solar powered battery charger for use with the
Mighty Mule 571W/572W
gate operator
systems. Particularly suited for remote installations, each
Solar Panel
comes with tubular steel support, mounting clips,
wire connectors, and 10 ft. of low voltage wire (see Low Voltage Wire for additional wire). The
Mighty Mule
control board
has clearly labeled terminal connections for easy installation of the
Solar Panel
. Installation in some regions of the world
will require multiple solar panels for adequate charging power.
Push Button Control (FM132)
Unlit doorbell button for remote entry or exit control. Wires directly to the control board and uses 16 gauge stranded, dual
conductor low voltage wire (sold separately).
Pin Lock (FM133)
The
Pin Lock
substitutes for the clevis pin at the front end of the Mighty Mule gate operators. Helps prevent theft of the
operator from the gate, while allowing quick release of the operator.
MMK200 Keypad
The Mighty Mule Wireless Keypad is designed to control access to all Mighty Mule Garage Door Openers. This keypad
features a LED back light that allows you to see numeric keys throughout dark or unfavorable weather conditions.
®
Mounting Post (FM100) - In Ground
This black powder coated pedestal is designed to provide convenient access to your keypad, wireless intercom, or other
access control device from your vehicle. With its break down design it is easy to install and works well in most standard
applications. Surface Mount Flanges (F102) and Extensions (F103) for added height are available.
Mighty Mule Vehicle Sensor (FM138)
The Gate Opening Sensor is designed for residential and agricultural applications and is compatible with most Mighty Mule
automatic gate operator models. The Sensor is an electromagnetic sensor, which offers ‘hands free’ operation of the Mighty
Mule Gate Operator with a 12 ft. radius of detection of vehicles in motion.
Automatic Gate Lock Pull-to-Open (FM143)
A
MUST for added security. Solenoid driven, with a steel housing. Used with
Mighty Mule
DC swing gate operating systems
for maximum stability and security. Comes with a keyed manual release.
AUTO
MATIC
GATE
LOCK
®
ELECTRONIC SECURITY LOCK
If you have a question about any special order item, call 1-800-543-4283
The contents of all material available on this installation manual are copyrighted by Nortek Security and Control, LLC (“Nortek Security and Control”), unless otherwise indicated. All
rights are reserved by Nortek Security and Control, and content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except with
the prior, written permission of Nortek Security and Control. Any reprinting of Nortek Security and Control publications is by permission only. Copyright infringement is a violation of
federal law.
Mighty Mule¨, E-Z Gate¨, Nortek Security and Control¨, “Dual Sense Technology” are registered trademarks of Nortek Security and Control, LLC, America’s DIY Automatic Gate Openers
is a trademark of Nortek Security and Control, LLC and are the exclusive property of Nortek Security and Control, LLC (“Nortek Security and Control”).
All rights are reserved by Nortek Security and Control, and these marks may not be used, in any for without the prior, written permission of Nortek Security and Control.
MMT103
The MMT103 Code Safe digital transmitter is a wireless radio control designed for use with Mighty Mule garage
door openers and can also be programmed to your Mighty Mule gate openers. One remote for two or three devices.
®
Wireless Entry Intercom / Keypad (MM136)
Allows owner to screen guest at the gate before allowing access to the property. Keypad also allows owner to give
up to 25 programmable entry codes to family, friends or approved delivery personnel. Codes can be permanent or
temporary. Up to 500 feet reception.
Additional base stations available (MM136B).
Low Voltage Wire (RB509)
The 16 gauge, stranded, dual conductor
Low Voltage Wire
is for connecting the AC powered transformer, or the
Solar Panel
to the control board. Also used for the connection of accessories, such as locks, keypads, push buttons
and other wired control devices. This specially designed wire is UV treated, PVC coated and ready for direct burial.
Available in 1000’ rolls or special lengths.
Replacement Transformer (RB571)
19V, 2A, DC transformer for maintaining the battery with the
Mighty Mule
gate operator.
Garage Door Receiver (RB709U-NB)
The Garage Door Receiver allows you to use the same
Mighty Mule
entry transmitter to operate your gate operator
and your garage door operator. Compatible with most garage door operators.
Driveway Alarm (FM231)
This device alerts you of vehicles entering your driveway (with or without an automated gate). The indoor base
station signals you with a door chime when a vehicle passes the driveway sensor.
Wireless Driveway Vehicle Sensor (FM130)
Automatically activates gate operator “Hands-Free” when a vehicle exits the property. 100 ft. range between
transmitter and receiver. Easy installation.
Wireless Connectivity System (MMS100)
Adds smart functionality to your gate operator utilizing the Mighty Mule App.
PAIR
RESET
