EasyGrid User Guide
26
6.11
RS-485/RS-422 Ports
A RS-485/RS-422 serial port is provided on the EasyGrid. It can be use to connect the EasyGrid to any
RS485 or RS422 communication bus. It also allows multiple EasyGrids to be link together.
IMPORTANT
When linking many EasyGrids on the same party line, make sure that all units have a different network
ID. The factory-defined address for all units is one (1).
The port is accessible using the dedicated terminal block. The pin layout is the following
A set of dip switches are used to configure the port. They are located behind the access plate on the
right of the screen
Switch
RS-422 Mode
RS-485 Mode
7
Must be
Left
Must be
Right
6
Must be
Left
Must be
Right
5
Must be
Left
Right
: Adds a 120
Ω
End of Line resistor
Left:
No end of line resistor
4
Must be
Left
Right
: Adds a 1k
Ω
pull up resistor
Left:
No pull up resistor
3
Must be
Left
Right
: Adds a 1k
Ω
pull down resistor
Left:
No pull down resistor
Label
RS-422
Mode
RS-485
Mode
B+
RX +
Data +
A-
RX -
Data -
B’
+
TX +
Do Not Apply
A’
-
TX -
Do Not Apply
GND
Ground
Ground
Summary of Contents for EasyGrid V1
