SURELOK MANUAL 2002
24
OPEN HEIGHT ADJUSTMENT:
The stroke of the SURE-LOK is factory set at 1" (or optional ½”). This will give a maximum
open height - (the gap between the punch and the die), of 1" or ½”.
This gap may be easily reduced, to eliminate a "pinch point" by adjusting a screw in the
center of the top of the WAMP power unit as shown in the drawing below. Reducing the
open height has no effect on the joint strength, or any other adjustments on the machine.
TOP OF WAMP UNIT
PROCEDURE:
1)
Disconnect the air supply and drain the air tank.
2)
Loosen the open height-locking nut.
3)
Adjust the open height screw with the hex key supplied with the tool kit until the
required daylight gap is obtained (the maximum gap is the same as the stroke of
the machine - 1").
4)
Re-tighten the locking nut.
Do not over tighten - there is an "O" ring seal below the locking nut.
5)
Re-connect the air supply.
10)
This adjustment will not effect the joint and the die will not have to be adjusted.
Summary of Contents for Sure-Lok 24
