SURELOK MANUAL 2002
23
SETTING LASER:
WARNING!!
ALTHOUGH THIS LASER IS A VERY LOW POWER DEVICE AND CANNOT
BURN, IT COULD CAUSE EYE DAMAGE WITH PROLONGED DIRECT EYE
EXPOSURE.
NEVER LOOK DIRECTLY INTO THE LASER OR POINT IT AT
ANYONE.
1)
The SURE-LOK can be fitted with a laser guide to help locate the center of the joint.
2)
The laser bracket is mounted as shown on the right side of the "C" frame, with the
Laser holder mounted on top of the bracket.
3)
The laser is powered by a low voltage power supply that is plugged into any 110v
receptacle.
4)
The laser is turned on by a small switch on the back of the unit. There is a beam
cover on the front of the laser that can be swung out of the way.
5)
If necessary the laser can be focused with a small tool provided with the laser, the
focus ring is in the front of the laser. Let the laser beam shine through the focus tool.
6)
To set the position of the laser spot on the material:
a)
Using a small sample (say 2" square) of the materials to be joined, scribe a
cross in the center of the sample.
b)
Place the sample on the lower tooling with the cross in the center of the die.
c)
Set the laser so that the laser point is centered on the cross (focus the laser if
required).
d)
Operate the press and make a joint.
e)
Check to see if the joint is at the center of the cross, if not, adjust the laser
position.(see next step)
f)
Repeat with a new sample but this time set the cross to the center of the
laser point.
g)
Make a joint and check to see if the joint is in the center of the cross.
h)
Repeat these steps until the alignment is correct.
Summary of Contents for Sure-Lok 24
