SURELOK MANUAL 2002
12
TOOLING:
1)
The clinching punch and stripper are located in the upper tooling and operate
through the stroke of the machine (Usually 1” or ½”). The punch may be easily
adjusted, through an inspection plate in the front of the barrel, to suit different
material thickness.
2)
The clinching die is located in the lower arm of the machine. Different dies may be
selected, and easly installed to suit different material thicknesses.
3)
Both the punch and die are of a very special design and should not be sharpened.
4)
Under normal operation both punch and die should last for approximately 200,000
to 300,000 cycles.
AIR TANK:
1)
The air reservoir tank is located on the back of the machine.
2)
The air surge tank features a 3/4" filter/regulator, which is set to 100 psi. for the
Medium Duty tooling and 80 psi. for the Light Duty tooling.
The filter should be drained regularly and cleaned as required.
3)
There is a safety blow-out valve mounted on the tank set at 135 psi. Do not remove
this valve. If the valve blows out reduce the inlet pressure to the tank to 125 psi.
4)
Drain moisture from the tank daily using the drain valve located at the base of the
tank.
Summary of Contents for Sure-Lok 24
