16
Applicators PatternCoat
P/N 7135308_08
E
2014 Nordson Corporation
PatternCoat
Setting Application Width
CAUTION:
Adjust the application width only when the applicator is heated.
Otherwise cold material will damage the applicator.
1. Release piston rod clamp (2).
2. Use the adjusting ring (1) to adjust the application width. Ensure that the
adjusting ring clicks into place.
NOTE:
The adjusting device is set at the factory such that the lower
edge of the piston just reveals a groove (3) when the adjusting ring is
locked in place. This effectively seals the next groove. If the application
width deviates 3 mm during application: Adjust the adjusting device
again. Refer to
Changing Direction of Application
(page
3. Tighten the piston rod clamp.
1
3
3 mm
2
Cross‐section
Summary of Contents for PatternCoat Series
Page 30: ......
