9
MEG® II Airless Spray Guns with 10 ft Cable
© 2021 Nordson Corporation
Pressure Transducers
When the MEG II gun is installed as part of a iTrax spray monitor system, install the
pressure transducer in the gun manifold to monitor fluid pressure at the gun. Refer to
Pressure Transducer
on page 31 for transducer ordering information.
Refer to the pressure transducer instruction sheet included with this manual for more
installation instructions.
See Figure 2.
Remove a plug and O-ring (9) from one side of the manifold and replace it with the
pressure transducer. The port on either side of the manifold can be used. Tighten the
transducer securely.
CO-Plate
When the MEG II gun is installed as part of a iTrax spray monitor system, install a CO-
plate in the gun manifold to produce a controlled pressure drop when the gun is spraying.
Refer to the
CO-Plate Selection Chart
on page 32 for CO-plate ordering information.
See Figure 2.
Remove the plug and O-ring (10) from the front of the MEG gun and install a CO-plate in
the manifold. Tighten the CO-plate securely.
