Nordson EcoDry
r
Series Induction Dryers with Touch Screen Controls
10
Part 1601306
−
02
E
2014 Nordson Corporation
System Positioning and Mounting
See Figure 6 for lift points and uncrated weight.
Flow Direction
The dryer must be positioned so that can ends pass through it in the correct
direction. When moving the dryer into position in the production line, note
the position of the motion sensor head. This is the dryer entrance. A flow
direction arrow is also located inside the coil tray.
NOTE:
Optional magnetic separators are always installed at the exit end of
the dryer.
Clearances
Provide clearances around dryer as follows:
S
Make sure blower intake (filters), and vents are not obstructed.
S
Provide enough space in the rear of the dryer to remove the access
panel for power and interlock connections and repairs.
S
Provide enough space in front of the dryer to open the enclosure doors.
Mounting and Line Connections
The dryer legs are made at the factory to the height listed in the purchase
order. Level the dryer and bolt it to the floor.
See Figure 7. Six evenly spaced
1
/
4
−
20 NCB threaded holes are provided
in the dryer exit and entrance hubs. Secure your can end rod cages or
trays to the entrance and exit hubs as required.
