Nordpeis New York Corner, Installation Manual, Page: 5 / 20

5
GB
New York Corner
Insert
N-24
Steel chimney
Can be installed with steel chimney.
Weight including insert 327 kg
Safety distances (FIG 1)
Ensure that the safety distances are complied with.
Please note that these safety distances can vary from
country to country.
A
The distance from the glass in the door to a lateral
wall, measured diagonally, must be of at least 800 mm.
B
The distance between the top of the convection air
outlet and roof of inflammable material must be at least
500 mm.
The distance to any inflammable material in front of the
opening of the insert must be of at least 1 m.
*The illustration indicates the approximate center height
of the hole for the flue. Distortions in floors and walls
may influence the height. Dry stack the fireplace until
the mantelpiece element for accurate height and
positioning of the flue/chimney connection. If a
fresh air supply set is connected through the floor, mark
where the hole** should be.
Assembly instructions (FIG 2 - FIG 16)
FIG 2: Place the bottom plate in 90º relative to the
chimney/wall. If needed, adjust with wedges or powder
glue.
FIG 6: If the fireplace is connected to a chimney at the
top, the smoke lid must be moved to the rear flue outlet.
FIG 8: Make sure there is a gap between the insert and
the surround as the insert expand with heat. Also read
the section about adjustment.
Fresh air supply (accessory FIG A)
For more information see separate assembly
instructions for fresh air supply.
When the fresh air supply is passing through the floor, a
hole needs to be cut in the bottom plate of the fireplace.
See the illustrations in FIG A for recommended area for
the hole.