8
8.
Make sure that all parts are properly tightened before you use the treadmill.
Keep the included allen
wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
6. After the treadmill is moved to the location where it will
be used (see HOW TO MOVE THE TREADMILL on
page 30), make sure that both Rear Feet (5) and both
Wheels (not shown) rest firmly on your floor. If the
treadmill rocks slightly on your floor, loosen the Rear
Foot Locknut (113) above the right Rear Foot. Turn the
right Rear Foot clockwise or counterclockwise until the
rocking motion is eliminated. Then, retighten the Rear
Foot Locknut.
5
113
6
5. Plug the indicated end of the Power Cord (48) fully into
the treadmill as shown.
48
5
4.
Be careful to avoid pinching your hands, the Wire
Harnesses (not shown), or the TV Cable (not shown)
during this step.
While a second person holds the Uprights (95, 97), re-
move the two Upright Bolts (96) used in step 1. Next,
slide the Uprights fully onto the brackets on the Frame
(not shown). Attach each Upright with four Upright Bolts
(96) as shown.
Firmly tighten all eight Upright Bolts.
Firmly tighten the eight Handrail Bolts (99).
5
113
99
99
99
95
96
96
97
4
7.
Note the location of the 75 ohm antenna terminal on
the treadmill. For the television to operate properly,
an antenna, a 75 ohm CATV cable, or a VCR must be
connected to the 75 ohm antenna terminal (see page
9).
75 Ohm
Antenna Terminal
7
