background image

6.

Make sure that all parts are properly tightened before you use the treadmill.

Keep the included allen

wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 28). 

To protect the

floor or carpet from damage, place a mat under the treadmill.

30

7

5. Insert two Handrail Bolts (104) with Handrail Bushings

(106) into the right Upright (99) and the right Handrail
(83). 

Be careful not to pinch the wires.

Make sure

that the Handrail Spacers are flush against the right
Upright, with the thick sides facing the centre of the
treadmill, as shown in the inset drawing. Next, lift the
right Handrail (83) slightly and align the Bolts with the
holes in the Handrail. Thread the Bolts into the
Handrail. 

Do not tighten the Bolts yet.

Attach the left Handrail (not shown) in the same way.
Then, 

tighten all four Handrail Bolts (104).

5

104

106

Thick

Side

99

106

4. Have a second person hold the Handrails (83) near the

Uprights (99). Connect the Upright Wire Harness (119) to
the wires extending from the Console Base (80) (see the
inset drawing). 

The connectors should slide together

easily and snap into place. If they do not, turn one
connector and try again.

Then, insert the connectors

and the Upright Wire Harness into the hole in the right
Upright. 

Set the Handrails on the Uprights, being careful not to
pinch the wires. 

119

99

80

83

4

83

CONDITIONING GUIDELINES

The following guidelines will help you to plan your ex-
ercise program. For more detailed exercise informa-
tion, obtain a reputable book or consult your physician. 

EXERCISE INTENSITY

Whether your goal is to burn fat or to strengthen your
cardiovascular system, the key to achieving the 
desired results is to exercise with the proper intensity.
The proper intensity level can be found by using your
heart rate as a guide. The chart below shows recom-
mended heart rates for fat burning and aerobic exercise.

To find the proper heart rate for you, first find your age
near the bottom of the chart (ages are rounded off to
the nearest ten years). Next, find the three numbers
above your age. The three numbers define your “train-
ing zone.” The lower two numbers are recommended
heart rates for fat burning; the higher number is the
recommended heart rate for aerobic exercise.

To measure your heart rate during exercise, use the
pulse sensor on the console.

Fat Burning

To burn fat effectively, you must exercise at a relatively
low intensity level for a sustained period of time.
During the first few minutes of exercise, your body
uses easily accessible 

carbohydrate calories

for en-

ergy. Only after the first few minutes does your body
begin to use stored 

fat calories

for energy. If your goal

is to burn fat, adjust the speed and incline of the tread-
mill until your heart rate is near the lowest number in
your training zone. 

For maximum fat burning, adjust the speed and incline
of the treadmill until your heart rate is near the middle
number in your training zone.

Aerobic Exercise

If your goal is to strengthen your cardiovascular sys-
tem, your exercise must be “aerobic.” Aerobic exercise
is activity that requires large amounts of oxygen for
prolonged periods of time. This increases the demand
on the heart to pump blood to the muscles, and on the
lungs to oxygenate the blood. For aerobic exercise,
adjust the speed and incline of the treadmill until your
heart rate is near the highest number in your training
zone.

WORKOUT GUIDELINES

Each workout should include the following three parts:

A Warm-up—

Start each workout with 5 to 10 minutes

of stretching and light exercise. A proper warm-up in-
creases your body temperature, heart rate and circula-
tion in preparation for exercise. 

Training Zone Exercise—

After warming up, increase

the intensity of your exercise until your pulse is in your
training zone for 20 to 60 minutes. (During the first few
weeks of your exercise program, do not keep your
pulse in your training zone for longer than 20 minutes.)
Breathe regularly and deeply as you exercise—never
hold your breath.

A Cool-down—

Finish each workout with 5 to 10 min-

utes of stretching to cool down. This will increase the
flexibility of your muscles and will help prevent post-ex-
ercise problems.

EXERCISE FREQUENCY

To maintain or improve your condition, complete three
workouts each week, with at least one day of rest be-
tween workouts. After a few months, you may com-
plete up to five workouts each week if desired. The key
to success is to make exercise a regular and enjoyable
part of your everyday life.

WARNING:

Before beginning this

or any exercise program, consult your physi-
cian. This is especially important for individu-
als over the age of 35 or individuals with pre-
existing health problems.

The pulse sensors are not medical devices.
Various factors, including the user's move-
ment, may affect the accuracy of heart rate
readings. The pulse sensors are intended
only as exercise aids in determining heart rate
trends in general.

Summary of Contents for 1600 Treadmill





















Reviews: