11
WARNINGS
Installation recommendations
−
The installation of the appliance must only be made by the manufacturer
’
s service personnel or
similarly
skilled person
;
−
Correct positioning of the counter.
−
Make sure that the support plane is leveled for the bench to work properly to avoid unexpected
noise (normally the sound pressure is less than 70 DbA).
−
Check that the mains voltage corresponds to that provided on the identification plate.
−
This equipment may not be used in the open air and can not be exposed to rain.
−
Connect the appliance to an efficient earthing system.
−
Installation and the electrical connection must be performed in compliance with national and local
standards in force.
−
For the replacement of the cable and plug use only original factory spare parts.
−
Connect the power cable to a plug that is easily accessible even after the counter is positioned.
−
Isolate the power circuit upstream by means of an omnipolar circuit breaker switch with a mini-
mum contact opening of 3 mm.
ATTENTION:
The arrangement and amount of products must not exceed the load limit.
We also recommend making sure that the full load is not excessive for the structure of the counter.
The following are the approximate capacity values of the shelves.
Respect these indications as much as possible
.
N.B.:
it is important that the full load of 350 Kg is not exceeded for a 1250 mm
module.
> 80mm
Do not cover
Maximum capacity
bottom shelf 160 kg
Maximum capacity
hanging shelf 20 kg
