Norco Eco-Stim NC89481, Instruction Manual, Page: 3 / 23

5 4
4) Press the [ON/OFF/M] button to turn on the device.
The LCD will light up, and then go into standby mode.
Based on your needs, press [ON/OFF/M] button to select
the treatment mode:
5)
Select treatment program.
Based on your needs, press
[P] button to select the treatment program.
6) Set program parameter. Press and hold [P] button to enter
the setting mode. In programs p1 to p6 of the TENS mode,
and programs p1 to p5 of the EMS mode, Press [+]/[-] button
to adjust treatment time. (More info on pg. 25)
7) In programs U1 to U3 of the TENS mode, and programs
U1 to U3 of the EMS mode, press [P] button to adjust pulse
rate -> pulse width -> treatment time by setting the
parameters. Press [+]/[-] button to adjust.
8) Start treatment. Press the [+]/[-] button of CH1 or CH2 to
increase or decrease intensity.
9)
Stop treatment.
Press [ON/OFF/M] button to stop treatment
and return to the standby mode.
QUICK REFERENCE GUIDE
Please read the instruction manual completely before attempting
to use this device. Steps 1-3 should be completed with the device
turned off.
1)
Open the battery cover, insert four batteries (type AAA) into
the battery compartment. Make sure you are installing
the batteries properly. Place the batteries according to the
markings of positive te) and negative terminal(-)
in the battery compartment of device. (More info on pg.17-18)
2) Insert the electrode wire connector into the electrode
connector. Make sure the two components are properly
connected to ensure optimal performance. Select one of
the two available channels and insert the lead wire firmly
into the device port.
3) Place the electrode on the location where you feel pain.
Refer to section 5.4.3 for correct electrode placement for
different body parts after reading 2.2.1 Contraindications
and 2.2.3 Precautions.